ASTM C827 PDF

The standard ASTM C a “Change in Height at Early Ages of Cylindrical Specimens from Cementitious Mixtures” [2] describes a method. ASTM C Standard Test Method for Change in Height at Early Ages of Cylindrical Specimens from Cementitious Mixtures. Lab ID: Use This test is used. ASTM A/AM Steel, Sheet and Strip, Heavy-Thickness Coils, Hot- Rolled, Carbon, Commercial, Drawing, Structural, High-Strength Low-Alloy.

Author: Tojajar Mojinn
Country: Turkmenistan
Language: English (Spanish)
Genre: Software
Published (Last): 7 April 2009
Pages: 41
PDF File Size: 4.10 Mb
ePub File Size: 17.60 Mb
ISBN: 860-9-86065-534-7
Downloads: 36917
Price: Free* [*Free Regsitration Required]
Uploader: Tagrel

Instructions Submit all necessary asym to perform test including mixing instructions, mix design. The maximum change in height will be reported, maximum decrease, maximum increase, change in height at set time and change in height at conclusion of test. Order Form 2 Email complete form to contact listed below.

Results Produced All height change measurements will be reported as percent change over time.

ASTM C827/C827M – 16

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine ast, applicability of regulatory limitations prior to use. If you need more info or have any satm, please note the Lab ID number and contact us at: It would be appropriate to use this test method as a basis for prescribing mixtures having restricted or specified volume change before the mixture becomes hard. Link to Active This link will always route to the current Active version of the standard.

  266DDH ABB PDF

However, the specimen used in this test method is not completely unrestrained so that the measurements are primarily useful for comparative purposes rather than as absolute values.

Further, the degree of restraint to which the specimen is subjected varies with the viscosity and degree of hardening of the mixture. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

If you need more info or have any questions, please note the Lab ID number and contact us at:. Contact Mike Morrison for additional information.

These notes and footnotes shall not be considered as requirements of the test method. It is particularly applicable to grouting, patching, and form-filling operations where the objective is to completely fill a cavity or other defined space with a freshly mixed cementitious mixture that will continue to fill the same space at time of hardening.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

  ANAEROBIC JAR OXOID PDF

These include shrinkage or expansion due to hydration, settlement, evaporation, and other physical and chemical effects. Time for Results Please contact a CTLGroup chemical services representative or Project Manager to discuss your individual project needs and testing response times.

Privacy Policy Sensors Sitemap. MSDS must accompany all samples submitted.

ASTM C Height Change at Early Ages of Cementitious Mixtures | CTL

Historical Version s – ashm previous versions of standard. Print and complete the following order form. Combining values from the two systems may result in non-conformance with the standard. Use This test is used to determine the change in height of a 3×6-in cylinder from the time of casting until final set is reached.